Using the IR remote control, press the following button combinations subsequently (one after one, not all at same time) to control certain parts of your camera:
[*] → [#] → [4] : Reset the OSD Menu to English
[*] → [#] → [6] : Restore factory defaults
[*] → [#] → [9] : Flip switch (temporary flip the image, active until the next reboot)
[*] → [#] → [Manual] : Restore the default username, password, and IP address
[#] → [#] → [#] : Clear all presets
[#] → [#] → [0] : Switch the video format to 1080p60*
[#] → [#] → [1] : Switch the video format to 1080p50*
[#] → [#] → [2] : Switch the video format to 1080i60*
[#] → [#] → [3] : Switch the video format to 1080i50*
[#] → [#] → [4] : Switch the video format to 720p60*
[#] → [#] → [5] : Switch the video format to 720p50*
[#] → [#] → [6] : Switch the video format to 1080p30*
[#] → [#] → [7] : Switch the video format to 1080p25*
[#] → [#] → [8] : Switch the video format to 720p30*
[#] → [#] → [9] : Switch the video format to 720p25*
[*] → [#] → [F1]: The camera is set to IR channel 1.
[*] → [#] → [F2]: The camera is set to IR channel 2.
[*] → [#] → [F3]: The camera is set to IR channel 3.
[*] → [#] → [F4]: The camera is set to IR channel 4.
* The camera will maintain the selected resolution even after a soft reboot, which is not the case after a hard reboot (when the camera is unplugged from mains and replugged): it will return to the video output setting of the rotary dial
IMPORTANT: 720p30, 720p29.97 and 720p25 are not supported by the SDI and HDMI outputs.
** See CM4x/CM7x IR remote control buttons