Using the IR remote control, press the following button combinations subsequently (one after one, not all at same time) to control certain parts of your camera:


[*] → [#] → [4] : Reset the OSD Menu to English

[*] → [#] → [6] : Restore factory defaults

[*] → [#] → [9] : Flip switch (temporary flip the image, active until the next reboot)

[*] → [#] → [Manual] : Restore the default username, password, and IP address (without having to reset the whole camera configuration, nor having to reboot the camera! )

[*] → [#] → [Auto] : Enter into the aging mode, only for quality control purposes

[#] → [#] → [#] : Clear all presets


[#] [#] [0] : Switch the video format to 1080p60*

[#] [#] [1] : Switch the video format to 1080p50*

[#] [#] [2] : Switch the video format to 1080i60*

[#] [#] [3] : Switch the video format to 1080i50*

[#] [#] [4] : Switch the video format to 720p60*

[#] [#] [5] : Switch the video format to 720p50*

[#] [#] [6] : Switch the video format to 1080p30*

[#] [#] [7] : Switch the video format to 1080p25*

[#] [#] [8] : Switch the video format to 720p30*

[#] [#] [9] : Switch the video format to 720p25*


[*]  [#]  [F1]: The camera is set to IR channel 1.

[*]  [#]  [F2]: The camera is set to IR channel 2.

[*]  [#]  [F3]: The camera is set to IR channel 3.

[*]  [#]  [F4]: The camera is set to IR channel 4.


Note that the camera will maintain the selected resolution after a soft reboot but not after a hard reboot (if the camera is unplugged from mains and replugged). After a hard reboot, it will return to the video resolution set by the rotary dial ("System select" at the rear of the camera) where the only exception would be with the F position on the rotary dial: "Default (via OSD/Web GUI)", in that case it will maintain the selected resolution even after a hard reboot


* IMPORTANT: 720p30, 720p29.97 and 720p25 are not supported by the SDI and HDMI outputs.



** See CM4x/CM7x IR remote control buttons