Resetting the Camera

You can reset your camera to factory defaults in three ways:

  1. Via the IR remote control (with or without OSD)
  2. Via the Web GUI see guide
  3. Via an Avonic PTZ controller see guide

Note: This resets the IP address to 192.168.5.163.

Reset via IR Remote Control

To restore factory defaults, press the following combination on the remote:

  • [*][#][6]

Press each button one after another, not simultaneously.

Reset via OSD Menu

Press the MENU button on the IR remote to open the OSD menu on a monitor. Navigate to Restore Defaults and press HOME to confirm.

Use the LEFT/RIGHT arrows to select "YES" and press HOME to confirm.

Reset IP Configuration (CM4x/CM7x)

To reset only the IP configuration (IP address, gateway, DNS), use:

  • [*][#][Manual]

This also resets the admin username/password, but not user1/user2.

Reset IP Remote Control




Reset via Web GUI

Go to SYSTEM > Default and click the DEFAULT button.

Web GUI Reset

Default

If necessary, you can perform a factory reset. This restores all default settings.


Figure 47: WebGUI > SYSTEM > Default

Click on the button This will restore the factory defaults to perform a factory reset. When completed, the camera automatically reboots. The camera will be ready for use again after the boot cycle.