Use a PoE switch or external adapter. If both are connected, the DC power supply takes priority.
- IP Address: 192.168.5.163
- Username: admin
- Password: admin
- TCP or UDP Port: 1259
IP Streaming
Access the Web GUI to configure streaming options. Default IP: 192.168.5.163.
- Streaming with VLC
- Streaming with NDI Studio Monitor
- Streaming to YouTube
- Streaming via SRT
- Using vMix
- NDI to OBS Setup
NETWORK
Use the tabs on the NETWORK screen to define the appropriate Port, Ethernet and DNS settings.
Port Settings
Figure 39: WebGUI > NETWORK > Port Settings
You can define specific ports for the different streaming outputs and protocols the camera supports.
Make sure these settings don’t interfere with other uses and services on the same network.
Click SAVE to apply your settings. A small confirmation dialogue appears in the bottom right corner.
NETWORK - Ethernet
In this section, you can specify the IP settings for the Ethernet adapter.
Figure 40: WebGUI > NETWORK > Ethernet
Execute the following steps to save your settings:
Click SAVE to apply your settings. A small confirmation dialogue appears in the bottom right corner.
Reboot the camera.
NETWORK - DNS
Here, you can specify the Preferred and Alternative DNS Server.
Figure 41: WebGUI > NETWORK > DNS
Click SAVE to apply your settings. A small confirmation dialogue appears in the bottom right corner.
SYSTEM
You can use the SYSTEM tabs to define the desired system settings.
Connecting via LAN
Avonic IP cameras can be controlled by any device using the VISCA over IP protocol (see the command list in Appendix A - VISCA Settings and Command List).
Settings
By default, the IP address of the camera is "192.168.5.163" with "admin" for both the username and password. The control parameters for the CM93 series cameras are as follows:
- IP Address: 192.168.5.163
- Username: admin
- Password: admin
- TCP or UDP port: 1259
IP (Network) Connection
Execute the following steps to connect an Avonic PoE camera to a LAN:
- Use a standard (PoE) switch. If the unit is simultaneously connected to both PoE and its own power supply, the power supply will take priority. If the power supply is disconnected while PoE is present, the camera will remain operational without interruption.
- Ensure that addressing is done via IP. When using VISCA over IP, the ‘x’ in all the ‘8x’ addresses is always ‘1’, where the VISCA address in a VISCA over IP environment is always 1. (See Appendix A - VISCA Settings and Command List for more information.)
Figure 15: IP Network Connection Diagram
Camera does not respond to commands send over IP
Check if the Low Power Mode is set to ON. If so disable it.